installation of A1200P for dummies

Hi,
It's probably very easy but I'm still unsuccessful with installation of A1200P.
I followed the instruction as described here:
downloads.openvox.cn/pub/misc/How%20to%2...8_OpenVox_A1200p.pdf

I'm receiving the PCI card info (below) after lspci -vvvvv
05:0b.0 Communication controller: Tiger Jet Network Inc. Tiger3XX Modem/ISDN interface
Subsystem: Device 9100:0003
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 66 (250ns min, 32000ns max)
Interrupt: pin A routed to IRQ 5
Region 0: I/O ports at 1000
Region 1: Memory at fc414000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI+ D1- D2+ AuxCurrent=55mA PME(D0+,D1-,D2+,D3hot+,D3cold+)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
Kernel modules: opvxa1200, hisax


I followed precisely the instruction and the first problem I encountered was the command: dahdi_genconf (results below)
[trixbox1.localdomain dahdi-linux-complete-2.6.1+2.6.1]# dahdi_genconf
Empty configuration -- no spans
Empty configuration -- no spans




I hardly tried to make this happen and followed another manual by replacing the latest A1200p patch by downloading and configuring the opvxa1200.c with dahdi drivers. As a result the dahdi drivers installed correctly (see below)
###################################################
###
### DAHDI tools installed successfully.
### If you have not done so before, install init scripts with:
###
### make config
###
###################################################
make[1]: Leaving directory `/usr/src/dahdi-linux-complete-2.6.1+2.6.1/tools'
make -C tools config
make[1]: Entering directory `/usr/src/dahdi-linux-complete-2.6.1+2.6.1/tools'
install -D dahdi.init /etc/rc.d/init.d/dahdi
install -D ifup-hdlc /etc/sysconfig/network-scripts/ifup-hdlc
/sbin/chkconfig --add dahdi
DAHDI has been configured.

List of detected DAHDI devices:

No hardware found
make[1]: Leaving directory `/usr/src/dahdi-linux-complete-2.6.1+2.6.1/tools'


As you probably noticed the result I received was:No hardware found

Any idea, directions are more than welcomed.

Thank you in advance.
Rgds.

Hello

I think you just need to change another dahdi version and download it from our website :
downloads.openvox.cn/pub/drivers/dahdi-l...e-2.6.1+2.6.1.tar.gz
By the way you can refer to this manual (do not need to patch):
downloads.openvox.cn/pub/manuals/V2.2/En...AHDI_User_Manual.pdf

Best regards
upper.hua