A400P with SwitchVox

I've installed the A400P into the machine I have running SwitchVox.
Under Hardware Setup it says no devices detected.

In Advanced Hardware it lists:

06:00.0 Network controller: Tiger Jet Network Inc. Tiger3XX Modem/ISDN interface

Anyone got any ideas?

Hi ,which version of SwitchVox you are using ?
We have never made a test that running OpenVox Card on SwitchVox distribution.
As we kown,SwitchVox is not a open source PBX distribution,the OpenVox Cards possibly can not work on it ,but we will have a try to get more information .

i] Last edited by tim.june at 2011-8-11 13:42 [/i

I found out the issue.

No installation instructions came with the card, and I hadn't connected the power cable to the card....

I small instruction sheet in the box would have saved me 12 hours of pain!!!

I have tested A400P with SwitchVox SMB 4.5 (PBX build 23691) and it works very well wihtout any changes.You can see these messages if your card is seted up properly :

02:0b.0 Communication controller: Tiger Jet Network Inc. Tiger3XX Modem/ISDN interface
Subsystem: Unknown device b100:0003
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (250ns min, 32000ns max)
Interrupt: pin A routed to IRQ 19
Region 0: I/O ports at d400
Region 1: Memory at feaf9000 (32-bit, non-prefetchable) [size=4K]

If there is still any problem,please contact me with Email: This email address is being protected from spambots. You need JavaScript enabled to view it.

Regards,
Tim.June

i] Last edited by tim.june at 2011-8-15 15:23 [/i

:lol :handshake :victory: