I've installed a new Trixbox 2.2.1, compiled de opvxa1200 module successfully and loaded it with no problems. The card have a led light on by each module installed on the board (FXO and 2 FXS). I've connected a phone to each FXS module's cable tail and I cannot erar the dial tone.
What could be wrong?
I have the same situation. One FXS does not give dial tone, whereas the other I have does. Both configured the same.
* All LEDs on the card lights green
* Both showing up fine without errors when Zaptel loads
* Ztcfg reports everything fine
* Asterisk 'zap show channels' says OK
* 'zap show channel XX' says everything is OK
* when I go offhook Asterisk picks it up and starts a simple switch
* When I go onhook asterisk hangs up the channel
* When I call someone they can hear me, but I don't hear them
Once and a while after a full reboot I can hear a vague dial tone which quickly disappears. I suspect the FXS module is broken - can that be so?