keywords: ip pbx voip gateway gsm gateway

×

Notice

The forum is in read only mode.
  1. Forum
  3. Telephony Cards Support
  5. A400/800/1200 Series
  7. How to configure A800 and A400e in one server
× Questions about A400/800/1200 Analog Interface Card

How to configure A800 and A400e in one server

13 years 7 months ago #6254 by lisa.gao
Hi,
Please send SSH to my email. This email address is being protected from spambots. You need JavaScript enabled to view it. I'll check for you.
13 years 7 months ago #6295 by cylim
HI Lisa Gao,

Do you receive my email ?
13 years 7 months ago #6296 by lisa.gao
Hi,
When did you send tie email to me?
Sorry, I have not received your email yet. Please send it again.
13 years 7 months ago #6297 by cylim
email sent, received ?
13 years 7 months ago #6298 by lisa.gao
hi,
Have received.
13 years 5 months ago #6397 by dolmax
I'm also trying to install and run G400P with A400M.
OS: CentOS 5.4
Asterisk: 1.6.2.11
Dahdi_linux_complete: 2.3.0.1+2.3.0

Both cards are identified by dmesg;
Found an OpenVox G400P: Version 0.c0a9
opvxg4xx: slot 0 is Installed
opvxg4xx: slot 1 is Empty
opvxg4xx: slot 2 is Empty
opvxg4xx: slot 3 is Empty
opvxg4xx: Powering up all spans...


Module 0: Installed -- AUTO FXO (FCC mode)
Module 1: Installed -- AUTO FXO (FCC mode)
Module 2: Installed -- AUTO FXO (FCC mode)
Module 3: Installed -- AUTO FXO (FCC mode)
Found a Wildcard TDM: Wildcard TDM400P REV E/F (4 modules)
dahdi_transcode: Loaded.
I can use the gsm commands through channel 1 on G400P. I was not able to introduce A400M to Asterisk. I have tried using the following method to enable A400M, without any success.
modprobe dahdi
modprobe opvxg4xx
modprobe wctdm
dahdi_cfg
/etc/dahdi/system.conf
loadzone=nl
defaultzone=nl
#Span 1: opvxg4xx/0/1 "OpenVox G400P PCI Card 0" (MASTER) AMI/CCS
span=1,1,0,ccs,ami
#termtype: gsm
bchan=1
hardhdlc=2
#echocanceller=mg2,1

#Span 2: opvxg4xx/0/2 "OpenVox G400P PCI Card 0" AMI/CCS
span=2,2,0,ccs,ami
#termtype: gsm
bchan=3
hardhdlc=4
#echocanceller=mg2,3

#Span 3: opvxg4xx/0/3 "OpenVox G400P PCI Card 0" AMI/CCS
span=3,3,0,ccs,ami
#termtype: gsm
bchan=5
hardhdlc=6
#echocanceller=mg2,5

#Span 4: opvxg4xx/0/4 "OpenVox G400P PCI Card 0" AMI/CCS
span=4,4,0,ccs,ami
#termtype: gsm
bchan=7
hardhdlc=8
#echocanceller=mg2,7
  1. Forum
  3. Telephony Cards Support
  5. A400/800/1200 Series
  7. How to configure A800 and A400e in one server
Time to create page: 0.035 seconds
Powered by Kunena Forum