How to install G400P on Ubuntu 8.04 server

1. Please install those package first:

apt-get install linux-kernel-devel
apt-get install linux-headers-2.6.24-26-server
apt-get install gcc g++
apt-get install libncurses-dev

2. Download the drivers from:
http://downloads.openvox.cn/pub/drivers/bristuff/g400p/opvx-bristuff-0.4.0-RC3h.tar.gz

3. unpack the drivers
tar -xvzf opvx-bristuff-0.4.0-RC3h.tar.gz

4. use command to run the shell script and wait for a few minutes
cd opvx-bristuff-0.4.0-RC3h
./install.sh
cd asterisk
make samples
mv /etc/asterisk/chan_dahdi.conf /etc/asterisk/zapata.conf

5. About the configuration files and how to load g400p module please refer this link:
http://bbs.openvox.cn/viewthread.php?tid=846&extra=page%3D1

Dear Dennis
I followed your instructions and installed everything without any error. I got all output results those you put on your guide. But after restarting server PC, I loaded modules such as modprobe zaptel; modprobe opvxg4xx; ztcfg -vvvvvv, run asterisk and got following error:

[Apr 13 03:15:25] ERROR[4651]: asterisk.c:3090 main: Asterisk has detected a problem with your Zaptel configuration and will shutdown for your protection. You have options:
1. You only have to compile Zaptel support into Asterisk if you need it. One option is to recompile without Zaptel support.
2. You only have to load Zaptel drivers if you want to take advantage of Zaptel services. One option is to unload Zaptel modules if you don't need them.
3. If you need Zaptel services, you must correctly configure Zaptel.
root@test:/usr/src/opvx-bristuff-0.4.0-RC3h#

We shut downed server PC, and loaded modules such as modprobe zaptel; modprobe opvxg4xx; ztcfg -vvvvvv, run asterisk. There was not above error which means asterisk run without problem. We got following message:

Asterisk Ready.
*CLI> -- GSM Span 1 registered to network!

So we are wondering what is happening during the restarting server PC. Any idea?

Hello,
There is an unloading driver procedure during shutting down PC. The driver will restart again and be sure load correctly when you reboot the server PC.

Can you lemme kno how to configure G400P in freeswitch pretty pliz...........

for freeswitch, you must use asterisk as a gsm to sip gateway, then connect to freeswitch through sip