Not All gsm spans shown

I am using a VS-GGU-E2M0400 GSM Gateway,
There is a problem .
I have a master board with 4 slaves

first of all the I can not update slave boards.

Board Name Model Name Modem Description Software Version Hardware Version Build Time
master VS-GGU-E2M0400 850/900/1800/1900MHz@GSM
2.3.8 Date 2012-11-09 FPGA 11 Hardware 00 2017-10-10 16:38:04
slave2 VS-GGU-E2M0400 850/900/1800/1900MHz@GSM
2.3.1 Date 2012-11-09 FPGA 11 Hardware 00 2016-06-12 09:35:23
slave3 VS-GGU-E2M0400 850/900/1800/1900MHz@GSM
2.3.1 Date 2012-11-09 FPGA 11 Hardware 00 2016-06-12 09:35:23
slave4 VS-GGU-E2M0400 850/900/1800/1900MHz@GSM
2.3.1 Date 2012-11-09 FPGA 11 Hardware 00 2016-06-12 09:35:23
slave5 VS-GGU-E2M0400 850/900/1800/1900MHz@GSM
2.3.1 Date 2012-11-09 FPGA 11 Hardware 00 2016-06-12 09:35:23

the main problem is that i need to run uusd code.


But only have 4 spans


Openvox-Wireless-Gateway*CLI> gsm show spans
GSM span 1: Power on, Provisioned, Up, Active, Standard
GSM span 2: Power on, Provisioned, Up, Active, Standard
GSM span 3: Power on, Provisioned, Up, Active, Standard
GSM span 4: Power on, Provisioned, Up, Active, Standard


while there should be 20 spans

Also gsm channels are working fine

Would you please advise,

Best Regards

Hello,

1. first of all the I can not update slave boards.

---

> You can enter slave boards and update them one by one.
"ip address + slot number" to access slave board.
For example: http://192.168.2.122/2/cgi-bin/php/system-tools.php //slave2
http://192.168.2.122/3/cgi-bin/php/system-tools.php //slave3



2. But only have 4 spans，while there should be 20 spans

---

> For ssh, there is only 1 board's information.
You can use port 12346 , 12347, 12348 and 12349 to access salve2, slave3, slave4, salve5...

If you still have problem, you can add my skype: This email address is being protected from spambots. You need JavaScript enabled to view it.

Thanks a lot.
Problem Solved.
Regards