keywords: ip pbx voip gateway gsm gateway

×

Notice

The forum is in read only mode.
× Questions about D110/210/410 T1/E1/J1 PRI Cards

About the 410 Card detect problem

15 years 4 months ago #2391 by neoewtech
I have 4 ports openvox T1/E1 Card, but when using elastix to detect card,
the dmesg show Stopped TE4XXP, Turned off DMA.

And post my dmesg message, hope any body can assist me.

thanks!

Found a Wildcard FXO: Wildcard X100P
usbcore: registered new driver wcusb
Wildcard USB FXS Interface driver registered
usbcore: deregistering driver wcusb
INFO-xpp: revision trunk-r5744 MAX_XPDS=64 (8*8)
INFO-xpp: FEATURE: without BRISTUFF support
INFO-xpp: FEATURE: with PROTOCOL_DEBUG
INFO-xpp: FEATURE: with ECHO_SUPPRESSION
INFO-xpp: FEATURE: without XPP_EC_CHUNK
INFO-xpp: FEATURE: with sync_tick() from ZAPTEL
INFO-xpp_usb: revision trunk-r5744
usbcore: registered new driver xpp_usb
usbcore: deregistering driver xpp_usb
r4fxo: module license 'unspecified' taints kernel.
Registered tone zone 0 (United States / North America)
WANPIPE(tm) Hardware Support Module Stable 3.2.7.1.0 (c) 1994-2008 Sangoma Technologies Inc
WANPIPE(tm) Interface Support Module Stable 3.2.7.1.0 (c) 1994-2008 Sangoma Technologies Inc
WANPIPE(tm) Multi-Protocol WAN Driver Module Stable 3.2.7.1.0 (c) 1994-2008 Sangoma Technologies Inc
wanpipe: Probing for WANPIPE hardware.
wanpipe: No AFT/S514/S508 cards found, unloading modules!
Freed a Wildcard
Zapata Telephony Interface Unloaded
Zapata Telephony Interface Registered on major 196
Zaptel Version: 1.4.11
Zaptel Echo Canceller: OSLEC
Zaptap registered 'sample' char driver on major 33
Found TE4XXP at base address ea000000, remapped to e0912000
TE4XXP version c01a0000, burst OFF
FALC version: 00000005, Board ID: 01
Reg 0: 0x11fe1400
Reg 1: 0x11fe1000
Reg 2: 0xea000008
Reg 3: 0x00000000
Reg 4: 0x00000000
Reg 5: 0xea000014
Reg 6: 0xc01a0000
Reg 7: 0x10001f00
Reg 8: 0xea000020
Reg 9: 0xea000024
Reg 10: 0xea000028
Found a Wildcard: Wildcard TE410P (2nd Gen)
15 years 4 months ago #2392 by james.zhu
hello:
please show:
1) set the serial select back to 0 (wheel on the board)
2) run command: /usr/sbin/genzaptelconf -sdvM, show me your result
3) show me your result: cat /proc/interrups
4) tell me the status of LEDS after load the driver.
regards!
James.zhu

Time to create page: 0.026 seconds
Powered by Kunena Forum