Hi,
I'm trying to install a Openvox A400P with Elastix 2.3.0 but the card is not detected from the web interface. I used the Detect New Hardware button but it just received the message: No cards were detected on your system. Please press the "Detect New Hardware" button to detect new hardware.. Yes, I connected the card's mole connector.
Below some additional information:
[root@CentralTel ~]# lspci -v
=============================
04:01.0 Network controller: Tiger Jet Network Inc. Tiger3XX Modem/ISDN interface
Subsystem: OpenVox Communication Co. Ltd. Device 0001
Flags: bus master, medium devsel, latency 64, IRQ 177
I/O ports at e800
Memory at feb00000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2
Kernel modules: wctdm, wcopenpci, hisax
[root@CentralTel ~]# dahdi_hardware
====================================
pci:0000:04:01.0 wctdm- e159:0001 Wildcard TDM400P REV E/F
[root@CentralTel ~]# service dahdi start
=========================================
Loading DAHDI hardware modules:
wctdm: [ OK ]
No hardware timing source found in /proc/dahdi, loading dahdi_dummy
Running dahdi_cfg: [ OK ]
Thanks in advanced
Regards
i] Last edited by aerodesliza at 2012-7-10 09:13 [/i