keywords: ip pbx voip gateway gsm gateway

×

Notice

The forum is in read only mode.
× Questions about G400/G410 Cards.

Chipset Tiger Jet Network

12 years 3 weeks ago #7908 by f1700
Hi,
G400P a GSM card bought in that appears as dmesg to "Found a Wildcard TDM: Wildcard S400P Prototype (4 modules)" and lspci-vvvv as appearing on:

00:08.0 Communication controller: Tiger Jet Network Inc. Tiger3XX Modem/ISDN interface
Subsystem: Tiger Jet Network Inc. Device 0002

The analog fxo ports are OK, but nothing to get up the GSM. I tried with 2.0.1 chan_extra.[url=]Desfazer edições[/url]













There is the same chipset OpenVox tiger?Dicionário
  1. preposiçãoto
    at
    in
    with
  2. pronomeit
    you
    ye
  3. artigothe
12 years 3 weeks ago #7910 by Joe.Yung
Hello,

Can you get info like these by lspci -vvv?

02:0c.0 Unassigned class [ff00]: Device 1b74:0100 (rev 01)
Subsystem: Device 1b74:0104
Flags: slow devsel, IRQ 217
Memory at feae0000 (32-bit, non-prefetchable) [size=64K]
Kernel driver in use: opvxg4xx
Kernel modules: opvxg4xx

Could you wipe the golden finger with alcohol and replug again or check if this PCI slot has been disabled?

12 years 3 weeks ago #7911 by f1700
00:08.0 Communication controller: Tiger Jet Network Inc. Tiger3XX Modem/ISDN interface
Subsystem: Tiger Jet Network Inc. Device 0002
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 32 (250ns min, 32000ns max)
Interrupt: pin A routed to IRQ 209
Region 0: I/O ports at e400
Region 1: Memory at ec124000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI+ D1- D2+ AuxCurrent=55mA PME(D0+,D1-,D2+,D3hot+,D3cold+)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
Kernel driver in use: wctdm
Kernel modules: wctdm, hisax
12 years 3 weeks ago #7913 by Joe.Yung
Hi,

Could you switch it another PCI that working fine for analog card?

Or can I get access to your system? Contact me, please!

Time to create page: 0.036 seconds
Powered by Kunena Forum