keywords: ip pbx voip gateway gsm gateway

×

Notice

The forum is in read only mode.
  1. Forum
  3. Telephony Cards Support
  5. D130/230/430/830/1630 Series
  7. Elastix with D130E conflict
× Questions about D130/230/430/830/1630 Advanced T1/E1/J1 PRI Cards

Elastix with D130E conflict

6 years 10 months ago #11116 by DonBrown
I believe we're having a problem with an interrupt conflict. We have an Elastix MiniUCS
Elastix can see the card, but no matter what we do, it remains in alarm state.
[[email protected] ~]# dmesg | grep VPM                                                  
opvxd115 0000:05:00.0: VPM450: Not Present
[[email protected] ~]# cat /proc/interrupts
           CPU0       CPU1
  0:     958138     957777    IO-APIC-edge  timer
  8:          2          1    IO-APIC-edge  rtc
  9:          0          0   IO-APIC-level  acpi
 50:          1          1   IO-APIC-level  ehci_hcd:usb1, uhci_hcd:usb2
 58:      13872          0         PCI-MSI  ahci
 66:       9718          0         PCI-MSI  eth0
169:          0          0   IO-APIC-level  uhci_hcd:usb5
185:         18         22   IO-APIC-level  uhci_hcd:usb4
[color=#ffff00]193:     927448     926543   IO-APIC-level  uhci_hcd:usb3, opvxd115[/color]
NMI:          0          0
LOC:    1915907    1915906
ERR:         87
MIS:          0
[[email protected] ~]# lspci -vvvv
05:00.0 Network controller: OpenVox Communication Co. Ltd. D130P/D130E Single-port E1/T1 card (3rd GEN) (rev 15)
        Subsystem: Device 0005:0000
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 32 (8000ns min, 32000ns max), Cache Line Size: 64 bytes
        Interrupt: pin A routed to IRQ 193
        Region 0: Memory at dfb00000 (32-bit, non-prefetchable) [size=32K]
        Kernel driver in use: opvxd115
        Kernel modules: opvxd115

Is there a way to change the interrupt via the DIP switches? The unit only has 2 USB ports and if I disable them in the BIOS, I can't use the keyboard.

Crystal - I have added you to Skype.
6 years 10 months ago #11117 by crystal.han
Hi,
I have received your request.
6 years 10 months ago #11118 by DonBrown
Crystal - thank you for your quick help!
  1. Forum
  3. Telephony Cards Support
  5. D130/230/430/830/1630 Series
  7. Elastix with D130E conflict
Time to create page: 0.032 seconds
Powered by Kunena Forum