We have a NT1 from our telephone provider. I have installed the mini PCI card on the alix 3C board.
When I use the askozia software I can see that the card is recognized by the software. It gives 4 isdn interface.
When I connect the cable from the NT1 to the B200M No light go on. When I try to make a call to our isdn line. I get no signal.
I searched the documentation on the website and put the jumpers in the position for NT (network termination)
I tried with and without the power supply. Don't get any signal.
The cable I used is a 4 wire ISDN cable. I also tried a standard cat5 utp cable but no result.
Do you have some support?
Best regards,
Wim Van Clapdurp
TCS Computers BVBA
url:
www.tcs-computers.be This email address is being protected from spambots. You need JavaScript enabled to view it.
hello,
i think the isdn4bsd in askozia can not support our B200M well. the version of isdn4bsd must be updated. svn version of isdn4bsd has supported B200M.
regards!
james.zhu