B100e And Bt

Hi I am having a lot of trouble trying to get this card to work making an outbound call. I am using freepbx 2.11 and asterisk 1.8.I have installed the dahdi module and it shows

Cologne Chips - HFC-S PCI A ISDN card 0 [TE] [1]

OK

CCS/AMI

3/3

3

bri_cpe

In the freepbx cli if I issue the command dahdi show status i get
HFC-S PCI A ISDN card 0 [TE] OK 0 0 0 CCS AMI 0 db (CSU)/0-133 feet (DSX-1)If I issue the command dahdi show channels I get Chan Extension Context Language MOH Interpret Blocked State pseudo default default In Service 1 from-digital en default In Service 2 from-digital en default In ServiceI have setup a trunk and also an outbound route, however no matter what I change I cannot seem to make an outbound call. I am using this with a BT Isdn bri line.Please help if you can.

Not sure if this will help but I see this in the asterisk cli.
-- Executing [[email protected]:1] NoOp("SIP/701-00000003", "TRUNK Dial failed due to CHANUNAVAIL HANGUPCAUSE: 1 - failing through to other trunks") in new stack
-- Executing [[email protected]:2] Set("SIP/701-00000003", "CALLERID(number)=701") in new stack
-- Executing [[email protected]:6] Macro("SIP/701-00000003", "outisbusy,") in new stack

HI

Please show me the output of "pri show spans" .Add my Skype upper.hua .

Best regards
upper.hua

thanks,the responce to pri show spans is [align=center]PRI span 1/0: Up, Active [/align]
[align=center]I have added you on skype what timezone are you in. [/align]