A400P Hang up phone on dialing

Hello.
I'm using CentOS 6.4 (Kernel 2.6.32-358.2.1.el6.i686) Asterisk 1.8.20.0 and Dahdi 2.6.1.
I intastalled A400P with 1 FXS and 1 FXO modules, made all configurations. Now then I try to dial a number (press any digit) I get following message from CLI:
Hanging up on DAHDI/1-1
Hangup on DAHDI1/1-1
Then I try to dial again I get this:
Hanging up on DAHDI/1-1
Hangup on DAHDI1/1-1Hanging up on DAHDI/1-1
WARNING[15734]: chan_dahdi.c:5164 dahdi_set_hook: DAHDI hook failed returned -1 (trying 1): Device or resource busy
All works well before upgrade from CentOS 6.3 to 6.4 (I was forced to reinstall Asterisk after that)

Also, after reboot I see this in lspci -v output:
Network controller: Tiger Jet Network Inc. Tiger3XX Modem/ISDN interface
Subsystem: OpenVox Communication Co. Ltd. Device 0001
Flags: bus master, medium devsel, latency 64, IRQ 18 I/O ports at d800
Memory at fdcfd000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2
Kernel driver in use: netjet
Kernel modules: wctdm, hisax, netjet
How can I make wctdm load on boot instead of netjet?

i] Last edited by vlg at 2013-4-16 22:29 [/i

Hi,
You need to add netjet to blacklist:
vi /etc/modprobe.d/blacklist.conf
.......
# ISDN - see bugs 154799, 159068
blacklist hisax
blacklist hisax_fcpcipnp
blacklist netjet
Then restart the system.

Yes I already blacklisted netjet. Any clues about first problem?

Hi,
Send me remote access, i will check it for you.
Skype ID: tim.jjune
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.