AE2410P EC Module not detected

Linux Build: CentOS 6.0
Kernel: 2.6.32-71.29.1.el6.x86_64
Card: AE2410P
Driver: dahdi-linux-complete-2.4.0+2.4.0

The echo module is not being detected. I would appreciate some help. Here is the dmesg output

opvxa24xx 0000:01:06.0: PCI INT A -> Link[APC1] -> GSI 16 (level, low) -> IRQ 16
OpenVox A2410P version: 1.3
eth0: no IPv6 routers present
Module 0: Installed -- AUTO FXS/DPO
Module 1: Installed -- AUTO FXS/DPO
Module 2: Installed -- AUTO FXS/DPO
Module 3: Installed -- AUTO FXS/DPO
Module 4: Installed -- AUTO FXS/DPO
Module 5: Installed -- AUTO FXS/DPO
Module 6: Installed -- AUTO FXS/DPO
Module 7: Installed -- AUTO FXS/DPO
Module 8: Installed -- AUTO FXO (FCC mode)
Module 9: Installed -- AUTO FXO (FCC mode)
Module 10: Installed -- AUTO FXO (FCC mode)
Module 11: Installed -- AUTO FXO (FCC mode)
Module 12: Not installed
Module 13: Not installed
Module 14: Not installed
Module 15: Not installed
Module 16: Not installed
Module 17: Not installed
Module 18: Not installed
Module 19: Not installed
Module 20: Not installed
Module 21: Not installed
Module 22: Not installed
Module 23: Not installed
OpenVox VPM: Not Present
Found an OpenVox A2410P: Version 1.3 (12 modules)
OPVXHW loaded
dahdi_transcode: Loaded.
INFO-xpp: revision Unknown MAX_XPDS=64 (8*
INFO-xpp: FEATURE: without BRISTUFF support
INFO-xpp: FEATURE: with PROTOCOL_DEBUG
INFO-xpp: FEATURE: with sync_tick() from DAHDI
INFO-xpp_usb: revision Unknown
usbcore: registered new interface driver xpp_usb
dahdi: Registered tone zone 0 (United States / North America)

Hi！

First, you need to make sure your card is installed on the EC module , EC module is purchased separately.

Second, check the EC module and the board is between the cable is connected properly, or you can re-connect again.

I purchased the ec module with the card. I have already reconnected the data bus cable twice. I also tried this same card on a slackware build with no luck. I also noticed two flashing indicator leds on the card (the led to the right flashes faster than the left). I can't find any documentation that explains what they are for. I really need to get this module working because the pstn echo is effecting dtmf detection.

i] Last edited by jasonc at 2011-7-21 11:23 [/i

Hi
Please give me SSH. i will check it.

You can connect with me from: This email address is being protected from spambots. You need JavaScript enabled to view it.

i see the EC module

I see wow gold their warplanes troops. according had I. wow gold kaufen we certainly can reduce casualtie their warplanes troops would be nice.